Filter
Top Products
Groundsmaster 4000--D/4010--D Page 5 -- 11 Electrical System
Service Screen
The service screen (Fig. 13) contains machine opera-
tional information including hours and counts. Values
listed for these service menu items cannot be changed.
If the machine PIN has been entered to allow access to
protected menu items in the settings screen, the protec-
ted service menu items will be listed and available in the
service screen.
NOTE: If the protected menu items are available, PIN
will be shown in the upper right corner of the InfoCenter
display.
The options listed for hours include the following:
D Key On identifies the number of hours that the igni-
tion switch has been in the RUN position.
D Machine Run identifies the number of hours that the
engine has been running.
D PTO On identifies the number of hours that the ma-
chine has been operated with the cutting decks en-
gaged.
D High Range identifies the number of hours that the
machine has been operated in HI range speed (trans-
port).
D Service Due identifies the number of hours before
the next scheduled maintenance is due.
The o ptions listed for counts include the following:
D Starts identifies the number of times that the engine
has been started.
D Left Deck identifies the number of times that the left
side cutting deck has been energized.
D Center Deck identifies the number of times that the
center cutting deck has been energized.
D Right Deck identifies the number of times that the
right side cutting deck has been energized.
D Fan Reversals identifies the number of times that
the engine cooling fan has been operated in the reverse
direction.
D Fan -- Coolantidentifies thenumber oftimes thaten-
gine coolant temperature caused the engine cooling fan
speed to change.
D Fan -- Oil identifies the number oftimes that hydraul-
ic oil temperature caused the engine cooling fan speed
to change.
D Inlet identifiesthe temperatureof the inlet air intothe
engine intake system.
The protected menu items include the following:
D DPF Regeneration provides the necessary proced-
ure for stationary regeneration for the exhaust system
DPF (diesel particulate filter) on machines with a Tier 4
engine (models 30607 and 30609). If the engine ECU
identifies that a stationary DPF regeneration is neces-
sary, anadvisorywill occur onthe InfoCenterand thene -
cessary steps will be listed in the service screen menu.
D Traction Pedal allows the traction pedal sensor to
becalibrated (seeTraction Pedal PositionSensor Calib-
rationinthe Adjustments sectionofthis chapterfor calib-
ration procedure).
D Fan Reverse provides the necessary inputs to
cause the cooling fan to reverse direction. This protec-
ted menu item allows the demonstration of the fan re-
versal and would never be necessary to use on a
normally functioning machine.
To return to the main menu screen from the service
screen, press the back button (left button).
1. Service menu
2. Service items
3. Move to menu items
4. Choose menu item
5. Back button
Figure 13
Hours
Key On:
Machine Run:
PTO On:
92.5 Hours
88.4 Hours
63.7 Hours
1
5
3
4
5
2
3
Electrical
System