Filter
Top Products
Groundsmaster 4000--D/4010--D Page 5 -- 13 Electrical System
Settings Screen
The settings screen identifies the InfoCenter language
and units (English or Metric). The settings screen also
allows the operator to customize the backlight (bright-
ness) and contrast settings for the InfoCenter display.
If either the backlight (brightness) or contrast items a re
selected, the center button (--) or right button (+) can be
used to change the display settings.
Protected menus allows the machine PIN to be en-
tered so that hidden machine service screen items can
be viewed and modified. The protected service items in-
clude traction pedal sensor calibration, cooling fan re-
versal demonstration, Smart Power
TM
ON/OFF a nd
exhaustsystem DPFregeneration (Tier4engines).If the
protect settings is ON (see below), auto idle, mow
speed, transport speed and counterbalance are also in-
cluded in the protected menu.
To allow access to the protected menu items, enter the
four (4) digit pin PIN using the center and right InfoCen-
ter buttons. After PIN has been entered, a check mark
should be visible above center InfoCenter button. Press
center button and the InfoCenter display screen should
indicate“PIN” inthe upperrighthand cornerif thecorrect
PIN number was entered. Use back button to return to
Settings menu. The protected menu items should be
available in the Service menu and can be changed as
long as the ignition switch remains in RUN.
NOTE: The initial PIN will either be 1234 or 0000. If the
PIN has been changed and is forgotten, a temporary
PIN can be obtained from your Toro distributor.
Protect settings allows the settings for auto idle, mow
speed and transport speed to be hidden so they cannot
be changed unless the PIN is entered. If the protect set-
tings is ON, these settings will not be seen when using
the InfoCenteruntil theprotected menus isselected and
the machine PIN is entered. If protect settings is OFF
(default setting), settings for these functions will be vis-
ible onthe InfoCenter andcan be adjusted by the opera-
tor.
Reset Defaults allows machine settings to be returned
to factory defaults.
Auto Idle causes the engine speed to decrease to low
idleafterthe machine hasnot beenin useforthe settime
delay in seconds. Auto idle can be a djusted to 8, 10, 15,
20 or 30 seconds or the auto idle feature can be turned
OFF.
Mow Speed allows the maximum traction speed to be
adjustedwheninLOW (mow)speed.Mowspeedcan be
adjusted to 40%, 70% or 100%.
Trans.(Transport)Speed allows themaximum traction
speed to be adjusted when in HI (transport) speed. HI
speed can be adjusted to 40%, 70% or 100%.
Smart Power allows the Smart Power
TM
feature to be
turned OFF and ON.
To return to the main menu screen from the settings
screen, press the back button (left button).
1. Settings menu
2. Settings items
3. Move to menu items
4. Change menu item
5. Back button
Figure 17
Settings
Units:
Language:
LCD Backlight:
English
English
40%
+/--
1
3
5
3
4
5
2
Figure 18
Settings
Auto Idle:
Mow Speed:
Trans. Speed:
--
5
1
4
6
4
5
6
2
1. Settings menu
2. Settings items
3. Current setting
4. Increase setting
5. Decrease setting
6. Back button
7. PIN activated
+
20s
70 %
70 %
PIN
3
7
Electrical
System