Toro 30603 Lawn Mower User Manual


 
Groundsmaster 4000--D/4010--D Page 5 -- 31 Electrical System
Fuses
The fuse block is located under the controller covernext
to the operator seat (Fig. 28).
In addition to the fuses in the fuse block, a 60 Amp fuse
is included in the wire harness to protect the power cir-
cuitfor theoperator cab.Thisfuse residesin afusehold-
er near the fuse block (Fig. 28).
Fuse Identification and Function
UseF igure 29to identify eachindividualfuse andits cor-
rect amperage in the fuse block. The fuses have the fol-
lowing functions.
Fuse A--1 (7.5 Amp) protects power supply for the out-
puts of the front TEC controller.
Fuse A--2 (7.5 Amp) protects power supply for the out-
puts of the rear TEC controller.
Fuse A--3 (10 Amp) protects turn signal light circuit (if
equipped on models 30603 and 30605).
Fuse A--4 (10 Amp) protects headlight circuit (if
equipped).
Fuse B--1 (7.5 Amp) protects power supply for the out-
puts of the front TEC controller.
Fuse B--2 (7.5 Amp) protects power supply for the out-
puts of the rear TEC controller.
FuseB-- 3 (10 Amp)protectspowersupplyto theengine
ECU.
Fuse B-- 4 (10 Amp) protects operator air--ride seat cir-
cuit.
Fuse C--1 (7.5 Amp) protects power supply for the out-
puts of the front TEC controller.
Fuse C--2 (7.5 Amp) protects power supply for the out-
puts of the rear TEC controller.
Fuse C--3 (10 Amp) protects main power supply circuit.
Fuse C--4 (10 Amp) protects power point circuit.
Fuse D--1 (2 Amp) protects logic power circuit to the
front TEC controller.
Fuse D--2 (2 Amp) protects logic power circuit to the
rear TEC controller.
Fuse D--3 (2 Amp) protects power supply for the In-
foCenter display.
Fuse D--4 (10 Amp) protects power supply for the horn
(if equipped).
Fuse Testing
Turn ignition switch to the RUN position (do not start en-
gine).Withthefuseinstalledinthefuseblock,usea
multimeter to verify that 12 VDC exists at both of the ter-
minal test points on the fuse. If 12 VDC exists at one of
the fuse test points but not at the other, the fuse is faulty.
If fuse removal is necessary, make sure that ignition
switch is OFF and key is removed from switch. Remove
fuse from fuse block and check that fuse has continuity
across the fuse terminals.
Figure 28
1. Fuse block
2. 60 A mp fuse
3. Operator seat
1
2
3
Figure 29
AB
1
2
3
4
CD
FRONT
5
Electrical
System