Filter
Top Products
9-4-18 FRONT BRACKET
Match the mounting hole of the front bracket with the inlet port of the engine’s main bearing
cover.
Torque for the front bracket:
120 0u 140 kg-cm
Note: Set the front bracket so that the cooling air outlet window
of
the generator is positioned
in the upper side, and the slit section is positioned in the bottom side.
9-4-l 9 ROTOR
Mount the rotor onto the taper section of the crankshaft and clamp it with through bolts.
Note: Wipe off well oil or stains from the taper section.
Main Bearing Cover
Rotor
Through Bolt
Outlet Window
(Set position)
Slit Section
M8x18 Bolt (4 PCS.)
Fig. 9420
- 59 -