Filter
Top Products
r
Part to
Wuence remOve
Description
Precautions
Necessary
tools
,
34 i
Connecting i(l) Scrape off the carbon de-
: rod and posits from the cylinder
: piston
and piston head. Then? in j
order to remove the two
bolts, open the bending
section of the connecting
rod lock washer.
(2) Remove the oil scraper, 1
!
lock washer, and connect- I
1
ing rod cap from the
crankshaft.
:lO m/m box
i spanner or
/ 10 m/m spanner
35
!(3) Turn the crankshaft until
I
I
the piston comes to the top
I
position. Then push the
!
connecting rod to remove j
I
I
the piston from the cylin-
I
der top.
I
I
‘Piston bc
(1) Remove the piston from 1 Be careful not to
! Piston ring :
the connecting rod edge by i damage the inside i
undipping the two piston i of the rod edge.
pin clips.
(2) Open the ring joint wide Be careful not to
and remove the piston ring open the joint too
i
i
from the piston.
wide, or it will
break.
36
37
Crankshaft (1) Remove the woodruff key
(for the magneto).
:(2) Remove the crankshaft
i Be careful not to !
while tapping the magneto i damage the oil seal. I
tip.
I
i Mount ;(l) Remove the four M8 :
‘12 m/m box
flange nut of engine side i
i
& generator side I
! spanner or
I
) 12 m/m spanner
Piston Ring
Clip
Piston
/
Connecting Rod Cap
<--- Rod Lock Washer
;‘;
ti
G
F&. 9-3-26
Connecting Rod Bolt
-47-