Filter
Top Products
(5)
(6)
(7)
(8)
(9)
(10)
Remove the ignition plug, and pour 5 -
10 cc oil into the ignition plug hole. Then quietly
pull the startig nob of the recoil starter to distribute the oil to everywhere inside the
cylinder, and then mount the ignition plug.
Check bolts and nuts for looseness and tighten them more if necessary.
Set the engine switch at the “STOP” position.
Pull the starting nob of the recoil starter, and leave it at the position where some load is
felt.
After cleaning the generator well, wipe it with a cloth and use an anti-rust spray on it.
Cover the engine with veneer etc., and store it in a place with low humidity.
Note: Be careful when draining fuel from the fuel tank.
Don’t sprinkle water over the engine
while cleaning it.
- 96 -