Duplex Skew Correction Cable Removal
7-92 Removal/Replacement Procedures
Duplex Skew Correction Cable Removal
To remove the duplex skew correction cable:
1 Open the top cover.
2 Remove the duplex tray.
3 Remove the paper guide from inside the duplex tray (four screws).
4 Slide the skew correction guides toward the center of the duplex tray.
5 Remove the bracket holding the shaft in place (two screws).
6 Remove the screw holding the cable mounting plate in place.
7 Lift the skew correction guides and shaft up out of the duplex tray.
8 Remove two screws holding each pulley assembly in place.
9 Remove the spring from the cable.
10 Lift the skew correction cable and pulley assemblies from the duplex tray.
Replacement Notes:
The placement of the mounting bead is critical. Set it on precisely. Replace parts in this
order:
• First reinstall the pulley assembly.
• Then, wrap the cable three times around the drive gear pulley.
• Finally, connect the spring.
