A SERVICE OF

logo

Power Control Board Removal
7-38 Removal/Replacement Procedures
Power Control Board Removal
To remove the power control board:
1 Open the back cover.
2 Remove the paper feed drive cover (three screws).
3 Remove the power control board cover (one screw).
4 Disconnect CN9, CN10, CN11, CN12, CN13, and CN14.
5 Remove power control board (two screws).
Replacement Note:
Be sure that the back of the board is mounted properly in the frame slots.
Power Control
Board Cover
Paper Feed Drive Cover
Mounting Slots
CN11
CN12
CN10
CN9
CN13
CN14
Power Control Board Detail