A SERVICE OF

logo

Exit Cover Removal (Duplex)
Removal/Replacement Procedures 7-77
6 Remove the fuser drive cover (three screws).
7 Remove the exit pinch roller. (See page 7-68.)
8 Disconnect CN49 and CN51.
9 Remove the wiring harness for CN42, CN49, and CN51 from the exit cover.
10 Disconnect CN317.
11 Remove the four screws holding the exit cover in place (two front and two back).
12 Lift the exit cover from the printer.
13 Remove the solenoid from the exit cover (two screws).
Fuser Drive Cover
Mounting Screws
Back Detail