A SERVICE OF

logo

Vacuum Transport Unit Removal (Duplex)
Removal/Replacement Procedures 7-13
Vacuum Transport Unit Removal (Duplex)
To remove the duplex vacuum transport unit:
1 Open the top cover.
2 Remove the upper duplex roller cover (four screws).
3 Remove the lower duplex roller cover (four screws).
4 Disconnect CN22.
5 Remove the C-clip from the gas spring on the side marked “up.” Gently move the gas
spring out of the way so it does not block the wire harness area.
6 Remove the four harnesses stays holding the cable in place.
7 Remove the three ground screws.
8 Remove the vacuum transport unit (four screws).
Harness Stays
Ground Screws
CN22
Harness Stay
Spring Detail
Lower Duplex
Roller Cover
Upper Duplex
Roller Cover
Vacuum Transport