A SERVICE OF

logo

Open as PDF
next previous
Paper Exit Sensor Removal
7-78 Removal/Replacement Procedures
Paper Exit Sensor Removal
To remove the paper exit sensor:
1 Open the front, back, and top covers.
2 Remove the fuser.
3 Remove the operator panel. (See page 7-19.)
4 Remove the exit pinch roller. (See page 7-68.)
5 Disconnect CN49.
6 Remove the two screws holding the exit cover in place (one front and one back).
7 Tilt the exit cover assembly toward the center of the printer.
8 From the underside, remove the paper exit sensor (single screw).
CN49
Paper Exit Sensor Detail