Filter
Top Products
Hydraulic Installation 29
PN-46018 (Rev. 3/15/02)
#56038 Valve Kit & #46047 Hose Kit Cont’d
Verification of Control Movements
1. Refer to the Woods Loader Operator’s Manual to
complete the loader installation. At least 6” spacing
should be maintained
between valve, bracket, or
hoses and any tractor control (brake pedals, accelera-
tor, hand throttle, or hydraulic levers).
2. Comply with all Safety Rules and start the tractor.
3. Check that all hydraulic control lever positions
operate the loader movements correctly as shown in
Figure 35.
NOTE: When the optional auxiliary hydraulic control
is used for operating an attachment such as a grap-
ple, pushing the control lever forward should close the
attachment and pulling the lever rearward should
open the attachment. See Figure 36.
4. If loader movements do not respond correctly,
shut off tractor, relieve pressure, and reconnect prop-
erly. Loader control movements must be correct
before proceeding.
5. Once all hoses are connected correctly, start the
tractor and operate the loader to check for leaks.
Purge any remaining air from the hydraulic system.
6. When hose routings and correct loader opera-
tions are verified, identify each circuit by placing a
matching colored band around the male and female
quick-disconnect coupler set. The colored bands will
make re-installation easier when the loader is remove
from the tractor.
7. Attach the plastic tie straps (included in kit) every
20 inches around the hoses to keep them tightly bun-
dled and away from contact with the ground or other
moving parts on the tractor or loader.
8. Be sure the adequate slack is left in the hoses so
they can move as the loader moves through its full
range of motion.
9. Before operating the loader, make sure that the
Pre-Delivery, Delivery, and Pre-Operation Checklists
from the Operator section in the Loader Operator’s
Manual have been completed.
Figure 35 Single Lever Control Operation
● Handle Forward - Boom down
● Handle forward to limit - Float position
● Handle back - Boom up
● Handle to right - Dump bucket or attachment
● Handle to left - Rollback bucket or attachment
Figure 36 Auxiliary Control Operation
3
23
)/2$7 326,7,21
52//%$&.
/,)7
/2:(5
'803
/(9(5
&21752/
75$&725
)5217
23(1
&/26(
- +DQGOH IRUZDUG &ORVH JUDSSOH
- +DQGOH UHDUZDUG 2SHQ JUDSSOH