Filter
Top Products
18 Hydraulic Installation
PN-46018 (Rev. 3/15/02)
#56037 Valve Kit & #40547 Hose Kit Cont’d
Install Fittings to Tractor Hydraulic Line
Refer to Figure 17 and Figure 18.
1. If not done during installation of right rear loader
mount, remove the tractor hydraulic line connector
tube or adapter block (if equipped) as shown in Figure
2.
NOTE: If 90-degree elbow (4) includes a nut and
sleeve, discard them.
2. Connect adapters (2) to each 90-degree elbow
(4) and tighten.
NOTE: Use sealant on pipe threads.
3. Attach adapters (2) to PBY and IN hoses. Tighten
finger tight.
4. Route IN hose inside the right loader mount.
Install elbow onto end of tractor hydraulic line as
shown in Figure 18.
5. Route PBY hose inside right loader mount.
Remove plastic cap and install onto transmission end
of tractor hydraulic line as shown in Figure 18.
6. Point elbows up and slightly out to clear the
hydraulic Return line as shown.
7. Tighten elbows to tractor line and tighten hoses to
adapters.
Figure 18 Hose Hanger Bracket Installed
2. 315038 1/2 NPTF x 3/4 JICM Adapter
4. 40549 1/2 NPTM x M26 x 1.5M 90° Elbow
7. 360130 54” Hose
11. 480261 Clamp
12. 6128 1/4 NC Lock nut
13. 300057 1/4 NC x 3/4 Cap screw
2
/,1(
6833257
%5$&.(7
)520 /2$'(5 9$/9(
3%< 3257
75$160,66,21 (1'
72 /2$'(5
9$/9( ,1 3257
(1*,1( (1'