Filter
Top Products
14 Hydraulic Installation
PN-46018 (Rev. 3/15/02)
#40542 Hose Kit Cont’d
Connect Hoses to Tractor
1. Connect hydraulic hoses to tractor hydraulic cou-
plers as shown in Figure 14.
2. Refer to tractor operator’s manual for operating
the tractor hydraulic levers.
Figure 14 Hose Connections to Tractor
Hydraulic Couplers
11
+26(
6833257
'
$
%
&
Verification of Control Movements
1. Comply with all Safety Rules and start the tractor.
2. Check that all hydraulic control lever posi-
tions operate the loader movements correctly as
shown in Figure 15.
3. If loader movements do not respond cor-
rectly, shut off tractor, relieve pressure, and
reconnect properly. Loader control movements
must be correct before proceeding.
4. Once all loader functions are correct, start
the tractor and operate the loader to check for
leaks. Purge any remaining air from the hydraulic
system.
5. When hose routings and correct loader oper-
ations are verified, identify each circuit by placing
a matching colored band around the male and
female quick-disconnect coupler set. The colored
bands will make re-installation easier when the
loader is removed from the tractor.
6. Be sure that adequate slack is left in the
hoses so they can move as the loader moves
through its full range of motion.
7.
Before operating the loader, make sure that the
Pre-Delivery, Delivery, and Pre-Operation Checklists
from the Operator section in the Loader Operator’s
Manual have been completed.
Figure 15 Tractor Hydraulic Control Levers
● Control #1, Handle forward - Boom down
● Control #1, Handle back - Boom up
● Control #2, Handle forward - Dump bucket or
attachment
● Control #2, Handle back - Rollback bucket or
attachment
&21752/
&21752/