Filter
Top Products
22 Hydraulic Installation
PN-46018 (Rev. 3/15/02)
#56038 Valve Kit & #46047 Hose Kit Cont’d
Connect Controller to Cables
1. Slide the rubber control boot up out of the way.
Orient the controller as shown in Figure 24.
2. Using a vice, clamp the controller loosely.
3. Remove both cable retainer bolts.
4. Push the control lever to expose the bucket cable
actuator at the bottom of the controller. Thread the
cable end to the cable actuator and tighten.
5. Push the control lever and insert the bucket cable
collar into the control lever body. Replace the cable
retainer bolt and tighten.
6. Push the control lever to expose the boom cable
actuator at the bottom of the controller. Thread the
cable end to the cable actuator and tighten.
7. Release the control lever and insert the boom
cable collar into the control lever body. Replace the
cable retainer bolt and tighten.
8. Remove the controller from the vice.
Figure 24 Attaching Control Cables
to Control Lever
3
5(7$,1(5
%2/7
%220
&$%/(
&2//$5
%8&.(7
&$%/(
&2//$5
&21752/
/(9(5