Filter
Top Products
16 Hydraulic Installation
PN-46018 (Rev. 3/15/02)
#56037 Valve Kit & #40547 Hose Kit Cont’d
Assemble Control Valve Kit
1. Install the control lever:
a) Thread end of handle (9) into valve.
b) Align handle so that end with longer bend is
pointing toward the adapter fittings. Make sure
bends are in line with front and rear of valve.
c) Tighten jam nut (38) already installed on han-
dle.
d) Slide boot down over boot bracket.
2. The valve mounting plate contains two sets of
holes. Select the holes that will position the valve in
the desired location. Install the valve mounting plate
(8) to the right loader mount, using two 5/8 NC x 1-1/2
carriage bolts (40), flat washers (41), lock washers
(42), and nuts (43) as shown.
3. Install 3/8 NC x 1-1/4 carriage bolt (30) through-
back of mounting shoe, securing with flat washer (32),
lock washer (33), and nut (34).
Carriage bolts must be installed so that the head is
inside the loader mount.
4. Attach the valve mount to the valve plate so that
the control valve will be in the correct position for
operation. Secure with three 1/2 NC x 1-1/2 carriage
bolts (35), flat washers (36), lock washers (37), and
nuts (39) as shown.
5. Control valve must be positioned so that move-
ment of tractor controls is not restricted. Maintain at
least 6” spacing between control valve kit and any
tractor control (brake pedals, accelerator, hand throt-
tle, or hydraulic levers.) Check for clearances in the
operating position.
6. Torque all hardware to specifications given below.
Figure 17 2-Spool Control Valve Kit Assembly
8. 46340 Valve mounting plate
9. 56254 Bent handle
17. 56095 3/8 x 54” Hose
30. 20973 3/8 NC x 1-1/4 Carriage bolt
32. 565 3/8 Flat washer
33. 838 3/8 Lock washer
34. 835 3/8 NC Hex nut
35. 12735 1/2 NC x 1-3/4 Carriage bolt
36. 3598 1/2 Flat washer
37. 855 1/2 Lock washer
38. 13859 Jam nut
39. 1093 1/2 Hex nut
40. 5607 5/8 NC x 1-1/2 Carriage bolt
41. 3632 5/8 Flat washer
42. 1286 5/8 Lock washer
43. 230 5/8 Hex nut
2
TORQUE SPECIFICATIONS
Wrench
Bolt Size Required Torque
3/8 NC x 1-1/4 9/16” 35 lbs.-ft. (47 N-m)
1/2 NC x 1-1/2 3/4” 85 lbs.-ft.(115 N-m)
5/8 NC x 1-1/2 15/16” 170 lbs.-ft.(230 N-m)
39
40
41
42
43
36
37
35
8
17
9
38
32
33
34
30
CD5733