Filter
Top Products
Hydraulic Installation 25
PN-46018 (Rev. 3/15/02)
#56038 Valve Kit & #46047 Hose Kit Cont’d
Attach Control Cables to Valve
1. Thread jam nut (g) over threaded end of cable.
2. Slide retainer (f) over cable.
3. Thread adjuster (e) completely over cable.
4. Thread jam nut (d) onto cable.
5. Thread cable adapter (a) onto end of cable.
Adapter should be installed so that three threads on
the cable remain visible at the jam nut.
6. Remove screws from retainer (c) while keeping
retainer in place.
7. Attach adapter (a) to the valve spool using pin (b).
Thread adjuster (e) onto cable to hold pin (b) in place.
8. Install socket head cap screws (h) through the
assembly (c-f). Leave retainer (f) just loose enough to
allow adjuster (e) to be turned.
NOTE: Valve cable connect kit contains three sets of
socket head cap screws. Use 3/4” long screws for all
sections.
9. Turn the adjuster to remove all slack from the
cable housing and to keep the control lever centered.
Figure 29 Control Cable Assembly
Adjust Control Cable
1. Check control lever operation before starting trac-
tor. Lever should be centered and movement should
be equal in all directions except “float” position. Float
position is locked forward.
2. If the lever movement is not equal or the “float”
position cannot be engaged, adjust the cables as fol-
lows (refer to Figure 29):
3. Loosen the adjuster jam nut (g) and the retainer
cap screws (h) slightly so that adjuster (e) can be
turned by hand.
4. Rotate the adjust to move the control lever to cen-
ter position.
5. If the lever cannot be adjusted for correct opera-
tion, remove the adjuster (e) and disconnect the cable
adapter (a) from the valve.
6. Loosen the adapter jam nut (d) and turn the cable
adapter until movement is correct (lengthen cable by
turning 2 or 3 times).
7. Reconnect the cable adapter (a) and repeat cable
adjustment procedure (Steps 1-4).
8. When adjustment is complete, tighten jam nut (g)
and retainer cap screws (h) securely to hold cable
housing in place, but do not overtighten.
9. Torque cap screws to 10 lbs.-ft.
10. Use a plastic tie strap to secure the cables to the
loader mount.
3
h
CD5816
a
b
c
d
e
f
g
BUCKET
AUXILIARY
(OPTIONAL)
BOOM