Filter
Top Products
T6000 Saber Assembly Section 2-9
ASSEMBLY
MIRROR MOUNT
1. Remove the existing mirror bracket and mirror from the cab.
2 Remove the mirror and knob from existing bracket.
3. Install the supplied bracket (using supplied hardware) on the cab as
shown below.
4. Install the mirror with the knob on the supplied bracket as shown below.
Refer to the Parts section for details.
LIGHT MOUNT
1. Remove light and light bracket from hand rail.
2 Tape light back against the hand rail next to the cab.
3. At the base of the hand rail, cut through the rail 2” from the cab.
4. To disconnect the wiring for the light, cut the hand rail through the hole
where the wires extend.
5. On the cab ceiling, remove the speaker grill cover that is closest to the
hand rail.
6. Remove the plate inside the speaker cavity to reach the wire connectors.
7. Disconnect green connector and pull wire through the hand rail.
8. Then cut hand rail 2” from the frame.
9. Place a small amount of adhesive on outer edge of the lower hand
rail stub. Slide rubber cap on the stub.
10. Take second rubber cap and cut a small “X” at the end. Feed the light
wire through the cap, the hand rail, and back into the speaker cavity.
Re-attach green connector.
11. Attach the plate and speaker grill cover.
12. Place small amount of adhesive on outer edge of upper hand rail stub.
Slide rubber cap on the stub.
13. Mount light to mirror bracket as seen in Parts section.
A. Mirror/Light Mount Bracket
B. Existing Hardware
C. Distance the muffler screen is cut
back to fit the exhaust collar.
- Half distance from the top bolt
hole to the top of the screen.