Filter
Top Products
T6000 Saber Assembly Section 2-2
ASSEMBLY
CRANKSHAFT ADAPTER
If necessary remove the four cap-screws from the crankshaft pulley. Then install
the crankshaft adapter and spacer to the pulley with cap-screws and lock-washers
as shown in the parts section.
Before attempting to mount or service your Tiger mower, it is important to
read and understand all of the information in the Safety section of this manual.
Check complete shipment list against the packing list to make sure there are no
shortages. Make certain the tractor model is the appropriate one for the mower
received!
Use a floor jack, hoist or fork lift to lift or raise heavy parts whenever
possible whether mentioned or not.
Read and understand the entire assembly section instructions before attempting
to mount your Tiger mower. Refer to the parts section of this manual for detailed
illustrations to locate all parts.
TRACTOR PREPARATION
A: Remove right and left hand steps.
B: Disconnect battery cables from both batteries.
C: Remove the lower battery and it’s tray.
D: Remove engine side panels, or raise hood to access front pulley.
E: Remove plugs from tractor casting where main frame and pump
mount will be attached.
F: Remove any front weights and weight supports.
ADJUSTING REAR WHEELS
Raise rear of tractor onto jack-stands. Follow the instructions in the tractor
owners manual for adjusting tires and rims. The back wheels MUST be adjusted
to the widest setting. NOTE: This may require switching the wheels to opposite
sides of tractor. Also take note of any width restrictions when transporting by trailer.
(For ease of installation, it is best to leave the rear wheels removed during installation
of the mower.)