Filter
Top Products
T6000 Saber Assembly Section 2-8
ASSEMBLY
6 CYLINDER EXHAUST MOUNT
NOTE: This should be done after mounting the main frame.
1. Cut the tractor hood as shown below to accomodate modified exhaust turbo
tube.
2 Remove the muffler from existing turbo tube.
3. Remove existing turbo tube from tractor turbo.
4. Install the exhaust mounting bracket and supporting brace.
5. Install the modified turbo tube to the tractor turbo with existing hardware. Do not
tighten the hardware.
6. Install the exhaust clamp to the exhaust mounting bracket with the supplied
hardware. Refer parts section for the details.
7. Tighten the turbo existing hardware.
8. Cut the muffler 8” off at the top as shown below and weld the sweep back on to
the top of the muffler maintaining the same direction. Then install muffler to the
turbo tube with the existing hardware.