Filter
Top Products
T6000 Saber Assembly Section 2-6
ASSEMBLY
4 CYLINDER EXHAUST MOUNT
NOTE: This should be done after mounting the main frame.
1. Cut the tractor hood as shown in pic. # 1 to accomodate modified exhaust turbo
tube.
2 Remove the muffler from existing turbo tube.
3. Remove existing turbo tube from tractor turbo.
4. Install the exhaust mounting bracket and supporting brace.
5. Cut the existing tube at turbo end 4-3/8” from hole center as shown in pic. # 2
and 3. Discard remaining portion of existing tube.
6. Install the turbo end of existing tube to the tractor turbo.
7. Connect the supplied tube to the turbo end of existing tube using the sealing
clamp as shown in pic. # 4. Do not tighten the hardware.
8. Install the exhaust clamp to the exhaust mounting bracket with the supplied
hardware. Refer parts section for the details.
9. Tighten the turbo existing hardware first and then the rest of the hardware.
10. Cut the muffler sweep off at the top and replace with a raincap, if necessary for
shipping, as shown in pic. # 5. Then install muffler to the turbo tube with the
existing hardware.
Picture # 2 Picture # 3
Picture # 1