Filter
Top Products
T6000 Saber Assembly Section 2-5
ASSEMBLY
LIFT VALVE MOUNT
Install the valve mounting bracket to the inside of the right and left rear fender
frame tube as shown below. Align the valve mounting plate with the drilled holes. Mark
the center of one of the holes above and in line with the slotted holes in the valve
plate. Do not use any holes that will be used to mount the valve on the plate.
Mount the lift valve with the supplied hardware. Refer the parts section for the
details.
LOAD SENSE HOSE ROUTING
The lift valve uses the Pressure, Return and Load Sense on the tractors rear remotes.
The ports used are directly under the valve mounting plate.
The pressure hose is routed from the tractor remotes to the inlet port of the HP Filter
on the valve mounting bracket. Then, the outlet port of the HP Filter to the pressure port
on the lift valve.
The return hose runs from the return port of the lift valve to the tractor remotes.
The load sense line is routed from the load sense port of the lift valve to the load
sense port on the tractor rear remotes.
For more information refer to the Parts Section pages for a complete diagram of the
tractor valve hookup.
LOAD SENSE
RETURN
PRESSURE