Filter
Top Products
T6000 Saber Assembly Section 2-3
ASSEMBLY
JOYSTICK MOUNT STAND
Place the front edge of the support bracket 2 ¾” back from the lower right front
window. Rotate stand to be 2 ¼” from the right door frame as shown below. Be
sure that the location of the stand will allow clearance between the joystick and all
existing interior levers, etc.
Drill 3 holes to match control bracket and secure with cap-screws and nylock
nuts noted in parts section.
Cut a 2 ¼” hole in the floor from inside the cab. This hole is to be located 2 1/2”
away from the edge, and 4” from the metal edge by the right door. Install trim lock
around the metal edges of the hole, then route the cables through the hole. Next,
wrap the cables with the 6” split hose at the point they pass through the hole, and
secure with zip-ties.JOYSTICK MOUNT STAND
Place the front edge of the support bracket 2 ¾” back from the lower right front
window. Rotate stand to be 2 ¼” from the right door frame as shown below. Be
sure that the location of the stand will allow clearance between the joystick and all
existing interior levers, etc.
Drill 3 holes to match control bracket and secure with cap-screws and nylock
nuts noted in parts section.
Cut a 2 ¼” hole in the floor from inside the cab. This hole is to be located 2
1/2”
away from the edge, and 4” from the metal edge by the right door. Install trim lock
around the metal edges of the hole, then route the cables through the hole. Next,
wrap the cables with the 6” split hose at the point they pass through the hole, and
secure with zip-ties.