Filter
Top Products
BRUSH REMOVAL AND REPLACEMENT (continued)
8. To reinstall the brush holder assembly,
depress the spring-loaded brushes into the
holder and slip a suitable non-metallic, fairly
stiff retainer through the slots at the top and
bottom of the holder. A cable tie works well;
see Figure F.10. This will hold the brushes up
so that you can easily install the holder.
9. With the needlenose pliers, reinstall the red
and the black wires to the appropriate termi-
nals on the brushes. The red wire is inboard.
10. Slip the holder into position in the generator
end bracket. Be careful not to loosen the 2
attached wires.
11. Reinstall and tighten the 2 screws with the 1/4”
nut driver.
12. Slowly remove the non-metallic retainer from
the brush holder and let the brushes snap
back against the slip rings.
13. Check the wire connections or clearance and
tightness.
14. Snap the brush holder cover back into posi-
tion.
TROUBLESHOOTING AND REPAIR
F-33 F-33
BULLDOG® 140
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC