Filter
Top Products
INSTALLATION
A-7 A-7
BULLDOG® 140
PREMISES WIRING
The Bulldog® 140 is not recommended for premises
wiring.
The Bulldog® 140 does not have a combined 120/240
volt receptacle and cannot be connected to a premises
as described in other Lincoln literature.
Remember that the Bulldog® 140 is intended only for
backup, intermittent use power.
Certain electrical devices cannot be powered by the
Bulldog® 140. Refer to Table A.2 for these devices.
CIRCUIT BREAKERS
Auxiliary power is protected by circuit breakers. When
the machine is operated in high temperature environ-
ments, the breakers may tend to trip at lower loads
than normally.
Never bypass the circuit breakers. Without over-
load protection, the Bulldog® 140 could overheat
and/or cause damage to the equipment being used.
------------------------------------------------------------------------
CAUTION
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC