Filter
Top Products
45
2. After installing Master Radio Unit mounting hardware, connect the
Dual Radio Cable Connector (P3) to the Master Radio Unit. Tighten
the two jackscrews on P3.
3. Next route the Remote Control Cable (19B802554P3 or P4) between
Control Head and Master Radio locations. After installing Control
Head, connect Remote Control Cable Connector (P2) to Control Head.
4. Connect "IGN A+" lead, if option is desired. Be sure internal Switch
SW601 on Master Radio is set properly. Refer to Page 20 of this
manual for details.
5. Connect Accessory Cable (19B802554P6 or P7) Connector (P1) to
Control Head.
6. Connect Microphone and Accessories. Refer to Accessory Installation
Manual for proper connection of Accessories.
7. Now connect Remote Control Cable Connector (P1) to the Dual Radio
Cable Connector (P2), and tighten to jackscrews on P2.
8. Connect Power Cable, and Antenna, then install Master Radio Unit in
mounting bracket.
9. After installing Slave Radio Unit in its mounting hardware, connect
Dual Radio Cable (P1), and tighten jackscrews. Be sure SW601 setting
on Slave Radio Unit is same as for Master Radio Unit. Connect Power
Cable and Antenna to Slave Radio.
10. Check Dual Radio operation, using operator's manual as test guide.