Filter
Top Products
34
10. Recheck all connections and cables. Insert fuse into transmit fuse
assembly.
Figure 30 - Handle Assembly In LOCKED Position
DUAL CONTROL UNITS
The Dual Control feature can be configured for either front mount or for
remote mount Radio Units. Each configuration provides for a Main
Control Unit and an Auxiliary Control Unit. In the front mount
configuration, the Main Control Unit is on the Radio Unit itself (see
Figure 33), with the Auxiliary Control Unit located in a convenient
location. In remote mount configuration the Main Control Unit is
typically located in the vehicle cab, with the Auxiliary Control Unit
located in a convenient location (see Figure 34).
All Radio Units and Control Units in the Dual Control Unit
configuration MUST BE PROGRAMMED prior to final installation.
It is recommended that the units be first programmed at a Service
Center, then transferred to the user’s installation.
PRE-INSTALLATION PROGRAMMING
PROCEDURE --FRONT MOUNT
The Radio and Control Units must be programmed in a sequential
procedure, in order to provide each Control Unit with the proper
identification code.
1. Configure the ORION Front Mount Radio with the PC
Programming Assembly, as shown in Figure 31, Step 1. Program
the radio with the following files: