Filter
Top Products
36
PRE-INSTALLATION PROGRAMMING
PROCEDURE -- REMOTE MOUNT
The Radio and Control Units must be programmed in a sequential
procedure, in order to provide each Control Unit with the proper
identification code.
1. Configure the ORION Remote Mount Radio and Auxiliary Control
Unit with the PC Programming Assembly, as shown in Figure 32,
Step 1. Program the radio with the following files:
Personality name <USERPERS> User’s personality file
Radio Code OGXXXXX Latest radio code file
(G13 or later vintage)
ADI Code <SAME>
Radio Unit ID <SAME>
ORION Keypad File <CUBMAP> Keypad definition for
Control Unit B
ORION CU ID CU B Must be Control Unit B
2. Now configure the Remote Mount Radio, the Main Control Unit,
and the Auxiliary Control Unit together with the PC Programming
Assembly, as shown in Figure 32, Step 2. Program this
configuration with the following files:
Personality Name <USERPERS> User’s personality file
Radio Code <SAME>
ADI Code <SAME>
Radio ID <SAME>
ORION Keypad File <CUAMAP> Keypad definition for
Control Unit A
ORION CU ID CU A Must be Control Unit A
Note that the Main Control Unit has ID “A” and Auxiliary Control Unit
has ID “B” in this configuration.