Filter
Top Products
OUTLET MANAGED PDU
68
• Accept Break: Determines whether the port will accept breaks received from
the attached device, and pass them along to a connected port. When enabled,
breaks received at this port will be passed to any port this port is connected to,
and sent to the device connected to the other port. When disabled, breaks will
be refused at this port. (Default = On.)
• Multiple Logins: (Text Interface Only) If the Outlet Managed PDU is installed
in an environment that does not include communication via an open network
(local communication only), then the Multiple Logins parameter can be used to
determine whether or not multiple users will be able to communicate with the
unit at the same time. If this parameter is set to "Off" then only one user will be
allowed to communicate with the unit at a time. (Default = On.)
5.9.2. Network Parameters
In the Text Interface, these parameters are accessed via the Network Conguration
menu. In the Web Browser Interface, these parameters are found by placing the
cursor over the "Network Conguration" link on the left hand side of the screen, and
then clicking on the "Network Parameters" link in the resulting y-out menu.
Note:
The IP Address, Subnet Mask, Gateway Address and DHCP status
cannot be changed via the Web Browser Interface. In order to
change these parameters, you must access the Outlet Managed
PDU via the Text Interface.
• IP Address: (Default = 192.168.168.168.)
• Subnet Mask: (Default = 255.255.255.0.)
• Gateway Address: (Default = undened.)
• DHCP: Enables/Disables Dynamic Host Conguration Protocol. When this
option is "On", the Outlet Managed PDU will perform a DHCP request. Note
that in the Text Interface, the MAC address for the Outlet Managed PDU is
listed on the Network Status Screen. (Default = Off.)
Note:
Before configuring this feature, make certain your DHCP server is
set up to assign a known, fixed IP address. You will need this new
IP address in order to reestablish a network connection with the
Outlet Managed PDU.