Filter
Top Products
OUTLET MANAGED PDU
180
/BOOT Initiate Boot Cycle
Initiates a boot cycle at the selected plug(s) or Plug Group(s). When a Boot cycle is
performed, the Outlet Managed PDU will rst switch the selected plug(s) Off, then
pause for the user-dened Boot/Sequence Delay Period, then switch the plug(s) back
on. The /BOOT command can also be entered as /BO.
Note:
When this command is invoked in Administrator Mode or SuperUser
Mode, it can be applied to all Outlet Managed PDU plugs and Plug
Groups. When this command is invoked in User Mode, it can only
be applied to the plugs and/or Plug Groups that have been enabled
for the account.
Availability: Administrator, SuperUser, User
Format: /BOOT <s>[,Y] [Enter] or /BO <s> [Enter]
Where:
s The number or name of the plug(s) or Plug Group(s) that you intend to
boot. To apply the command to several plugs, enter a plus sign (+)
between each plug number. To apply the command to a range of plugs,
enter the numbers for the rst and last plugs in the range, separated by a
colon character (:). To apply the command to all plugs allowed by
your account, enter an asterisk character (*).
,Y (Optional) Suppresses the command conrmation prompt.
Example:
Assume that your account allows access to Plug A2 and Plug A3. To initiate a boot
cycle at Plugs A2 and A3, without displaying the optional command conrmation
prompt, invoke either of the following command lines:
/BOOT A2+A3,Y [Enter] or /BO A2+A3,Y [Enter]