Filter
Top Products
EURO • Printed in England • GB • F016 L69 838 • CLUB/ROYALE • OSW 08/01
English - 6
The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off, remove spark plug cap before investigating fault.
Fault Finding
Symptom Possible Cause Remedy
Mower leaves a ragged
finish
Cutter not correctly adjusted Adjust the cutter
Engine will not start Engine is flooded
Spark plug lead not connected
Spark plug dirty
no oil
Leave for 10–15 minutes
Reconnect
See engine maintenance manual
add oil
Engine stops No petrol
Engine speed too low for conditions
Cutting cylinder obstructed
Engine does not stop
Refill tank
Move throttle
Turn off engine and clear
obstruction
Throttle cable not correctly
adjusted. Stop engine by removing
spark plug lead and refer to the
engine maintenance manual.
Cutting cylinder does not
rotate
Incorrect adjustment Contact an ATCO Approved
Service Agent
Land drive does not
engage
Incorrect adjustment/cable damaged Contact an ATCO Approved
Service Agent
Excessive vibration/noise Blade(s) or/and cylinder bearing damaged
Engine fault
Contact an ATCO Approved
Service Agent
See engine maintenance manual
CLUB/ROYALE - Buch Seite 6 Dienstag, 7. August 2001 2:41 14
18 • F016 L69 838 • TMS • 11.07.01