Filter
Top Products
Preparing the Test Set for DC Operation
244
Preparing the Test Set for DC Operation
NOTE: Instructions for connecting the Test Set to AC power, or to an optional printer
(if desired) are provided in the Test Set’s User Guide.
Connection/Configuration for DC Power
1. Verify that the front panel power switch is off.
2. Set the rear panel AC/DC switch to the DC position (out).
3. Connect the user supplied power cable (HP P/N 08920-61078) to the rear
panel DC power connector. A DC connector is provided in the accessory kit
(optional). Connect the other end to facility DC power (11-32 Vdc @ 15A).
AC DC
DC INPUT
15A 11-32 VDC
DC
FUSE
AC FUSE
5A 250V
114.3
MHz
IF
IQ
RF IN
HEADPHONE
CW RF
IN
OPTION INTERFACE
CONTROL IO
AUDIO
MONITOR
10 MHz REF
INPUT
10 MHz REF
OUTPUT
EXT SCOPE
TRIGGER
CRT VIDEO
OUTPUT
MODULATION
INPUT
DC CURRENT
MEASUREMENT
SERIAL PORT
(OPTION)
HP-IB
(OPTIION)
PARALLEL PORT
(O PTIION )
DC POWER
CONNECTOR
DC POWER FUSE
DC POWER KEY