A SERVICE OF

logo

3-42 ENGINE
DISASSEMBLY
With holding the rotor with the special tool remove the starter
clutch bolts.
09930-44520: Rotor holder
Remove the one way clutch 1 and guide 2 from the rotor.
REASSEMBLY
When fitting the one way clutch 1 to the guide 2, position
flange side A of one way clutch to the rotor side.
When installing the starter clutch guide 2 to the rotor 3,
make sure that the flange B side faces outside.
Degrease the securing bolts and bolt holes.
Apply THREAD LOCK SUPER “1303” to the bolts and tighten
them to the specified torque while holding the rotor with the
special tool.
99000-32030: THREAD LOCK SUPER “1303”
Starter clutch securing bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
09930-44520: Rotor holder