240 C2631M-C (7/09)
Certain PTZ devices, like Pelco’s Spectra Series domes, will display an on-screen message with the amount of remaining memory available
for pattern programming.
Figure 214. Programming a Pattern Using Web Client
To stop programming a pattern:
1. Click the Pattern button .
2. Click the Set button .
Activating a Pattern
To activate a pattern:
1. Click a pattern number (1-4) on the keypad.
2. Click the Pattern button .
A pattern will repeat indefinitely until it is cleared, another pattern is set, or the on-screen PTZ control is moved.
Figure 215. Activating a Pattern Using Web Client
Clearing a Pattern
To clear a pattern:
1. Click the Set button to enter programming mode.
2. Select a pattern number (1-4) on the keypad.
3. Click the Pattern button .
4. Click the Clr button .
5. Click the Pattern button again.
ᕣ
ᕢ
ᕤ
ᕢ
ᕡ
