Control Panel for Large-Format Printers 4-11
4
HP DesignJet
Control Panel
5. Press
↑
to configure each TCP/IP parameter. For the first
parameter,
MIO SETUP
and
IP BYTE 1=<value>→
appear.
6. To maintain the current value, press
↑
.
7. To change the value, proceed as follows:
a. Press
[Enter]
to display the current value.
b. Press
↑
until the value that you want appears.
c. Press
[Enter]
to save the new value.
MIO SETUP
and
IP BYTE 1=<new value>→
appear.
d. Press
↑
to continue.
8. Configure the remaining bytes of the IP address in the same
manner. Note that a valid IP address is required for proper
operation.
9. If you want, configure the subnet mask bytes (
SM
), syslog server
IP address (
LG
), default gateway (
GW
), and timeout (
TIMEOUT
)
in the same manner.
The
TIMEOUT
parameter default is 90 seconds. Up to
3600 seconds can be configured. If set to “0”, the timeout
feature of the HP JetDirect card is disabled—TCP/IP
connections remain open until closed by the server.
10. Press
[Previous]
until
Ready to plot
is displayed.
For the 700/2000/2500/3000/3500 Series Printers
1. Access the configuration menu (see “To enable or disable
network protocols” in this chapter).
2. From the
CFG TCP/IP=NO→
menu item, press
[Enter]
,
↓
,
[Enter]
to display
CFG TCP/IP=YES→
.
3. Press
↑
to display “
BOOTP=
”.
a. To maintain the current “
BOOTP=
” setting, press
↑
.
b. To change the “
BOOTP=
” setting, press
[Enter]
,
↑
,
[Enter]
.
• If you select
BOOTP=YES→ ,
the printer is configured to
retrieve its TCP/IP parameters over the network using
BOOTP or DHCP.
No other TCP/IP prompts are displayed on the printer's
control panel. Press
↑
to continue with configuration of
other network protocols, or press
[Previous]
until the
STATUS Ready
is displayed.
