4-10 Control Panel for Large-Format Printers
NOTE
For DHCP (Dynamic Host Configuration Protocol)
operation, BOOTP must be enabled.
If an IP address is configured through DHCP and is
subsequently changed through the control panel,
the DHCP assigned address is released.
If a printer is configured through DHCP, and
you manually change the subnet mask or default
gateway through the control panel, you should
also change the IP address.
To configure TCP/IP parameters
If you haven't already done so, enable TCP/IP by following the
instructions described in “To enable or disable network protocols”
in this chapter.
For the 600 Series Printers
1. Access the configuration menu (see “To enable or disable
network protocols” in this chapter).
2. Press
[Enter]
, then
↑
, until
MIO SETUP
and
CFG TCP/IP=NO→
appear.
3. Press
[Enter]
, then
↑
, then
[Enter]
.
MIO SETUP
and
CFG
TCP/IP=YES→
appear.
4. Press
↑
.
MIO SETUP
and
BOOTP=YES→
or
BOOTP=NO→
appear.
a. To maintain the current “
BOOTP=
” setting, press
↑
.
b. To change the “
BOOTP=
” setting, press
[Enter]
, then
↑
,
then
[Enter]
.
• If you select
BOOTP=YES→ ,
the printer is configured to
retrieve its TCP/IP parameters over the network using
BOOTP or DHCP.
No other TCP/IP prompts are displayed on the printer’s
control panel. Press
↑
to continue with configuration of
other network protocols, or press
[Previous]
until
Ready
to Plot
is displayed.
• If you select
BOOTP=NO→
, the printer is configured to
accept TCP/IP parameters from the control panel.
