3-4 Using the Control Panel for Printers
8. Press
[Item]
to continue to the next protocol.
Example:
To enable the DLC/LLC protocol, press
[Item]
until the control
panel displays either
DLC/LLC=ON*
or
DLC/LLC=OFF*
.
If
DLC/LLC=ON*
is displayed, press
[Item]
to retain that protocol
and continue to the next protocol. This turns on the DLC/LLC
protocol.
If
DLC/LLC=OFF*
is displayed, press
[+]
and then press
[Select]
or
[Enter]
to change the protocol. Then press
[Item]
again to
continue to the next protocol.
9. To activate the printer and save your changes, press
[On Line]
(for LaserJet 5 Series printers, press
[Go]
).
To complete the print server configuration, see the HP JetDirect
software installation guide
included with the product.
Configuring Novell NetWare Frame Types
If the NetWare protocol is enabled (
IPX/SPX=ON*
), you can set the
NetWare frame type from the control panel. You can configure one
of the following frame type settings:
Novell NetWare Frame Types
on an HP JetDirect Ethernet Card
Frame Type Description
AUTO (default) Automatically senses and limits the frame type to
the one detected.
EN_8023 Limits the frame type to IPX over IEEE 802.3
frames. All others will be counted and discarded.
EN_II Limits the frame type to IPX over Ethernet frames.
All others will be counted and discarded.
EN_8022 Limits the frame type to IPX over IEEE 802.2 with
IEEE 802.3 frames. All others will be counted and
discarded.
EN_SNAP Limits the frame type to IPX over SNAP with
IEEE 802.3 frames. All others will be counted and
discarded.
