Using the Control Panel for Printers 3-17
3
Printer Control
Panel
4. Press
[Select]
.
CFG NETWORK NO
appears. This message
does
not
mean that you must reconfigure your protocol. It means
only that you do not intend to access the network configuration
menus.
5. Press
[Value]
to display
CFG NETWORK YES
. Then press
[Select]
.
6. Press
[Item]
until
CFG IPX/SPX NO
appears.
7. Press
[Value]
to display
CFG IPX/SPX YES
.
T
hen press
[Select]
.
8. Press
[Item]
until
SRC RT <Source Routing>
appears.
To change source routing, press
[Value]
until the source routing
that you desire appears, then press
[Select]
.
9. To activate the printer and save your changes, press the online/
offline button .
To complete the print server configuration, see the HP JetDirect
software installation guide
included with the product.
Configuring TCP/IP Parameters
If you have not already done so, enable TCP/IP (
TCP/IP ON
) by
following the instructions described above.
CAUTION
Enter data carefully. If you make an incorrect entry,
you may need to restart the procedure.
1. Take the printer offline by press the online/offline button .
2. Press
[Menu]
repeatedly until
MIO MENU
appears.
3. Press
[Item].
CONFIGURE MIO
appears.
4. Press
[Select]
.
CFG NETWORK NO
appears. This message
does
not
mean that you must reconfigure your protocol. It means
only that you do not intend to access the network configuration
menus.
5. Press
[Value]
to display
CFG NETWORK YES
. Then press
[Select]
.
6. Press
[Item]
until
CFG TCP/IP NO
appears.
