3-10 Using the Control Panel for Printers
To configure TCP/IP parameters
NOTE
For HP 2500C/CM Professional Series
and DesignJet ColorPro GA printers, see the
“HP 2500C/CM Professional Series and DesignJet
ColorPro GA Control Panel” instructions at the
end of this chapter.
If you have not already done so, enable TCP/IP (
TCP/IP=ON*
)
by following the instructions described in “To enable or disable
network protocols” in this chapter.
CAUTION
Enter data carefully. If you make an incorrect entry,
you cannot change it without starting again from
step 1.
1. Take the printer offline by pressing
[On Line]
or
[Go]
to indicate
offline.
2. Press
[Menu]
repeatedly until the following message is displayed
on the control panel:
3. Press
[Item]
until
CFG NETWORK=NO*
appears.
4.
Change the message to
CFG NETWORK=YES*
using the following
buttons:
5. Press
[Item]
until
CFG TCP/IP=NO*
appears.
4 Series printers
AUX IO MENU
4 Plus and 4V Series printers
MIO MENU
Color LaserJet printers
(
Proceed to Step 4
)
MIO CONFIG MENU
CFG NETWORK=NO *
4Si Series printers (select the
card slot being configured)
MIO MENU 1
or
MIO MENU 2
5Si Series printers (select the
card slot being configured)
HP MIO 1 MENU
or
HP MIO 2 MENU
5 Series printers
HP MIO MENU
5 Series and 5Si Series printers Press
[+]
, then
[Select]
Other printers Press
[+]
, then
[Enter]
