Control Panel for Large-Format Printers 4-1
4
HP DesignJet
Control Panel
4
Using the Control Panel
To Configure HP JetDirect Cards
in Large-Format Printers
Introduction
If you have an HP DesignJet printer listed below, you can manually
configure certain network parameters using the printer control
panel:
• DesignJet 3000CP/3500CP
• DesignJet 2000CP/2500CP
• DesignJet 755CM
• DesignJet 750C Plus
• DesignJet 750C
• DesignJet 700
• DesignJet 650C
• DesignJet 600
NOTE
For HP DesignJet ColorPro GA printers, see
chapter 3.
You can use the printer control panel to do the following:
• enable or disable network protocols
• configure Novell NetWare frame types
• configure Novell NetWare source routing for Token Ring
networks
• configure TCP/IP parameters
• configure Apple EtherTalk Phase parameters for Ethernet
networks
• configure timeout for sensing the end of a job
NOTE
The above parameters can also be configured using
the HP JetDirect software.
