Control Panel for Large-Format Printers 4-9
4
HP DesignJet
Control Panel
For the 700/2000/2500/3000/3500 Series Printers
1. Access the configuration menu (see “To enable or disable
network protocols” in this chapter).
2. From the
CFG IPX/SPX=NO→
menu item, press
[Enter]
,
↓
,
[Enter]
to display
CFG IPX/SPX=YES→
.
3. Press
↑
repeatedly until
SRC RT=AUTO
appears.
4. To change source routing, press
[Enter]
and
↓
until the source
routing that you want appears.
5. To save the new source routing setting, press
[Enter]
. (Press
[Enter]
again to verify your selection with “
*
”.)
6. Press
[Previous]
and return to
STATUS Ready
.
7. To save the configuration, print a configuration plot by pressing
the two arrow keys simultaneously. Your printer configuration
is now active.
To continue manually configuring other parameters, see the
appropriate sections in this chapter. To complete the print server
configuration, see the HP JetDirect software installation guide
included with the product.
Configuring TCP/IP Parameters
Using the control panel of your printer, you can manually configure
these TCP/IP parameters:
• You can configure BOOTP, which automatically downloads
configuration data over the network (this is the default setting)
or
• You can enter these parameters individually:
• IP address (4 bytes)
• Subnet mask (4 bytes)
• Syslog server IP address (4 bytes)
• Default gateway (4 bytes)
• TCP connection timeout (in seconds)
