Quick Installation 5
4. Verify that the card was installed correctly.
Print another test page (or
configuration plot) and verify
that the “I/O CARD READY”
message appears.
On the test page, the location
of the “I/O CARD READY”
message depends on your
printer model.
NOTE
If other messages appear, see the troubleshooting
sections of the
HP JetDirect Print Server
Administrators Guide
.
For HP J4100A (10/100Base-TX), see appendix B
in this manual for special troubleshooting
information.
5. Configure the card for network operation.
In most cases, you will use the
HP JetDirect software on the
CD-ROM. For some printers,
you can use the printer’s
control panel to configure
basic network parameters.
See chapter 3 (for HP
LaserJet, Professional Series,
and DesignJet ColorPro GA
printers) or chapter 4 (for
HP DesignJet large format
printers).
Location of "I/O CARD READY"
message on test page
