Filter
Top Products
6-17
LS 3070 Product Reference Guide: Programming
OCIA Transmit Timeout
When connected to an OCIA terminal, the RL 470 base/interface will attempt
to transmit the data to the host. If the host is not prepared to accept data at that
time (i.e., the host data buffer may be full), the RL 470 will try to retransmit the
data for up to 3 seconds. If transmission is not successful, the data will be
discarded, and the RL 470 will issue a transmission error.
This parameter allows you to increase the time the RL 470 will attempt
transmission before discarding the data. You can select up to a 30 second delay
in one second increments. During the time the RL 470 is attempting to transmit
data, no new data can be scanned.
NCR 2152 Fast Transmit
Selects the data transmission speed to the NCR 2152 POS terminal. Depending
on the version of NCR 2152, selecting this option may increase the possibility
of lost or mis-transmitted data.
IBM 4683/93 Magstripe Communications
The RL 470 base/interface communicates with the IBM 4683/84/4693/94 as a
scanner device, and also as a magstripe reader device. The RL 470/IBM 4683/
93 magstripe communications can be enabled and disabled via this parameter.
If the RL 470 magstripe capability is needed, this parameter should be enabled.
If not, it should be disabled to avoid contention with any other magstripe
reader which may be connected to the host.
International Keypad Emulation
This parameter is supported by IBM AT/XT/PS2 terminals only. The layout of
some international keyboards differ from that of American keyboards. To send
a given character, regardless of its physical location on the keyboard, enable
this parameter.
International Keypad Emulation Fast Transmit
This parameter is used when International Keypad Emulation is enabled.
Some IBM AT/XT/PS2s allow for faster transmission. With this parameter
enabled, the RL 470 transmits at a faster rate. Not all IBM AT/XT/PS2s support
a faster transmission rate.