Filter
Top Products
5-22
LS 3070 Product Reference Guide: Interface Guide
Fujitsu 9000 Installation
1. Switch-off the Fujitsu 9000, and disconnect the power. Push down on the
keyboard release latch below the keyboard. Pull the keyboard forward, lift
and remove
2. Press down the printer release tab. Push the printer back and remove. Press
down the display release tab. Push the display back and remove.
3. Remove the four screws securing the top plate to the chassis. Carefully lift
the top plate. Disconnect the 60-pin connector marked KB-PR-DISP from
the motherboard.
4. Remove one of the metal filler brackets at the left-rear corner of the chassis,
and insert the base station cable ends with the two 15-pin connectors.
5. By the connector marked KB on the top plate, remove the two phillips head
screws holding the connector plate to the top plate.
6. Remove the two screws holding the 15-pin D-type male connector to the
plate. Push the connector through the top plate.
7. Slide the insulating sleeve over the 15-pin D-type female connector on the
base station cable.
8. Attach the 15-pin D-type female connector on the base station cable to the
15-pin D-type male keyboard connector. Push the insulating sleeve down
over the two connectors and secure both sides with tie wraps. Connectors
must be completely insulated to prevent any possibility of shorting to
any component.
9. Push the 15-pin D-type male connector on the base station cable through
the KB opening on the top plate. Attach this connector to the connector
plate, making sure the small U-shaped spacer is between the connector and
the plate.
10. Attach the connector plate to the top plate with the small spacing washer
closest to the top plate. Attach the top plate to the terminal, re-inserting the
four screws.
11. Replace the display and printer. Replace the keyboard
You can now attach your scanner and peripheral devices.