Filter
Top Products
6-15
LS 3070 Product Reference Guide: Programming
Serial Response Timeout
This parameter determines the maximum period allowed to elapse before the
base station assumes end of transmission. The delay period can range from 0 to
9.9 seconds.
Stop Bit Select
The stop bit(s) at the end of each transmitted character marks the end of
transmission of one character and prepares the receiving device for the next
character in the serial data stream. The number of stop bits (one or two) selected
depends on the number the receiving terminal is programmed to accommodate.
Set the number of stop bits to match host device requirements.
ASCII Format
When enabled, this parameter transmits data in an 8-bit ASCII format. This
allows the base station to interface with devices requiring that protocol. The
default is 7-bit ASCII.
RTS Line State
In order to transmit, some hosts expect the RTS line to be in a certain state (High
or Low) when there is no hardware handshaking. This parameter will adjust the
RTS Line State.