Filter
Top Products
3-1
Chapter 3
Scanning with the LS 3070
1. Ready
Before starting to scan bar codes for data collection, make sure:
• The base station is connected to the host device.
• The battery has been charged.
• The scanner is paired with the base/charger.
2. Test
Aim the scanner toward a bar code and press the trigger. When you press the
trigger, the scanning beam is energized.
3. Scan
Make sure the symbol you want to scan is within the proper scanning range.
(See Decode Zones beginning on page 3-6.)
Aim and press the trigger.
• The scan beam and red SCAN LED will light for about 3 seconds, or until
a successful decode.
The scanner has read the symbol when:
• You hear a beep.
• The green DECODE LED lights.
The LED stays green for up to one second if the trigger is down or disappears
if you release the trigger. The scanner powers down after a successful decode.