Filter
Top Products
Black 0007
Black0007
3. TYPICAL SYSTEM SENSORS
DOOR/WINDOW SENSOR
◆
Sensor mounts on door or window with adjacent
magnet.
◆
Opening door or window moves magnet away,
triggering sensor.
◆
Internal lithium batteries are monitored by the
Console.
◆
Sends hourly status reports to the Console.
◆
Up to 3 years battery life (depends on frequency
of activation).
WIRELESS KEYPAD
◆
For controlling the system without having to go
to the Console.
◆
Emergency and fire alarm can be triggered from
wireless keypad at any time.
◆
Green operation light.
◆
Internal 9-volt battery is monitored by the
Console.
◆
Keypad’s beeper will buzz during transmissions
when the battery is low.
◆
Up to 3 years battery life (depends on frequency
of activation).
◆
Sends hourly status reports to the Console.
◆
Press the [
(A)
] key to activate the automation
output.
◆
Pressing [
∗
] clears the keypad.
◆
Holding [
∗
] for two seconds sounds the mode
beeps from the Console.
✔
Off Mode: 1 “Gong”
✔
Chime Mode: 1 “Gong” & 1 “Beep”.
✔
Home Mode: 1 “Gong” & 2 “Beeps”.
✔
Away Mode: 1 “Gong” & 3 “Beeps”.
✔
Test Mode: 1 “Bing” & 4 “Beeps”.
ABOUT SENSOR STATUS SUPERVISION
All DXS Format sensors transmit hourly status reports. All DXT
Format sensors do not transmit hourly status reports. Both
sensor formats can be used with the Console.
When a sensor is programmed into the Console, the Console
will set the sensor as non-supervised or supervised. Sensors
set as non-supervised are not expected to send hourly status
reports. Sensors set as supervised are expected to send
hourly status reports. If a status report is not received in 8
hours from a sensor set as supervised, the
TROUBLE
indicator will flash.
When sensors are programmed into the Console,
ALL
STATIONARY SENSORS ARE SET AS SUPERVISED, ALL
PORTABLE SENSORS ARE SET AS NON-SUPERVISED.
If stationary DXT Format sensors have been programmed
into the Console, be sure to change their setting to
non-supervised to prevent TROUBLE indications. This will
not prevent low battery monitoring.
If portable DXS Format sensors have been programmed
into the Console, and the installation requires supervision
for specific portable sensor(s), change the selected
portable sensors setting to supervised.
After programming the sensors, if changes are required, refer
to “Changing a Sensors Supervision” on Page 26 for details
on changing the way a sensor’s supervision is set.
5