Filter
Top Products
Black 0024
Black0024
11. CUSTOMIZING THE SYSTEM
◆
Adding additional sensors will increase the
protection provided by the system.
◆
All ground-level perimeter openings and
accessible upper-story openings need protection.
◆
Motion detectors can protect interior areas and
areas where valuables are kept.
ADDING SENSORS TO THE SYSTEM
Always start with the Console in Test Mode
(enter a user code and press [
TEST
]).
Enter the master user code then press the [
TEST
]
button.
❇
A “gong” and five “beeps” will sound.
❇
The sensor status indicators will light for each
sensor programmed into the Console.
Enter an
unused
sensor number from 01-24
(you must enter two digits, example: 5 = 05).
✍
NOTE: A sensor can be learned into more than
one location. Be sure to choose an
unused
sensor
number. If a sensor gets entered into more than
one location, delete the duplicates using the
remove sensor function.
❇
The sensor indicator light will flash for the sensor
number selected.
Activate the sensor. (To add a wireless keypad,
press the keypad’s [
∗
] key.)
❇
A single “bing” tone will sound when the sensor
is learned by the Console and the sensor status
indicator will stay lit.
Enter another sensor number or exit Setup Mode
by holding the [
OFF
] button for three seconds.
REMOVING SENSORS FROM THE SYSTEM
◆
If a previously learned sensor isn’t going to be
used with the system anymore, or it’s a duplicate
that has been entered into more than one sensor
location, it should be removed from the
Console’s memory.
◆
Start with the Console in Test Mode.
Enter the master user code then press the [
TEST
]
button.
❇
A “gong” and five “beeps” will sound.
❇
The sensor status indicators will light for each
sensor programmed into the Console.
Enter the sensor number (from 01-24) that you
want to remove (you must enter two digits,
example: 5 = 05).
❇
The sensor indicator light will flash for the sensor
number selected.
Press the [
TEST
] button.
❇
A single “bing” tone will sound when the sensor
has been removed and the sensor status
indicator will turn off.
Enter another sensor number or exit Setup Mode
by holding the [
OFF
] button for three seconds.
START IN TEST
MASTER
USER
CODE
1 GONG &
5 BEEPS
NEW
SENSOR
NUMBER
ACTIVATE
SENSOR
DONE
TEST
START IN TEST
MASTER
USER
CODE
1 GONG &
5 BEEPS
SENSOR
NUMBER
TO REMOVE
DONE
TEST
TEST
1 BING
22