Filter
Top Products
32
Section 4: Maintenance & Lubrication
RCR2596, RCR2510 and RCRM2510 Rotary Cutters 312-753M
5/09/08
Land Pride
Table of Contents
Lubrication Points
Tailwheel Spindle Tube
Lift-Type Cutter
Type of Lubrication: Grease
Quantity = 6 pumps
16276
Tailwheel Hub
The tailwheel hub is equipped with a relief hole located
directly opposite the grease fitting. The relief hole
releases pressure from inside the hub casting when it
is greased. The hub should be greased until grease
purges from the relief hole.
Type of Lubrication: Multi-purpose Grease
Quantity = Until grease purges from the relief hole
16278
Gearbox & T-Box
Check oil level in the gearbox by removing the side plug in
the gearbox case. If the oil level is low, remove the top plug
in the gearbox case and fill with80-90W EP oil until oil flows
from the side port of gearbox case. Reinstall plugs and
tighten.
Type of Lubrication: 80-90W EP Oil
Quantity = Fill until oil flows from the side port of gearbox
case.
NOTE: Do not overfill! Cutter should be level when
checking oil.
24
Hours
8
Hours
8
Hours
50
Multi-purpose
spray lube
Multi-purpose
grease lube
Multi-purpose
oil lube
Intervals in hours
at which lubrication
is required
Lubrication
Legend
22320