Filter
Top Products
13
Section 1: Assembly and Set-Up
5/09/08
RCR2596, RCR2510 and RCRM2510 Rotary Cutters 312-753M
Land Pride
Table of Contents
4. Install main driveline (#4) to jackshaft (#2) by pulling
on the collar and pushing the yoke forward to engage
the groove on the jackshaft splined stub until the
collar has locked in place. Make certain the locking
collar has engaged by pulling on the main driveline.
5. Tighten the set screw in the bearing locking
collar (#3).
6. Replace gearbox cover.
7. Secure chain (#5) on the main driveline (#4) to the
bearing support assembly (#3). Secure chain(#6) on
the jackshaft driveline (#2) to the hole on the left side
of the gearbox cover (cover not shown). Securing
chains will restrict driveline outer shields from
rotating.
RCR2596, RCR2510 & RCRM2510
Equal Angle Driveline Assembly
Figure 1-6
22303
Equal Angle Driveline Installation
Refer to Figure 1-6:
Equal angle drivelines can be installed on RCR2596,
RCR2510 and RCRM2510. Maximum turning angle is
limited to 35 degrees.
1. Remove gearbox cover (cover not shown).
2. Securely attach the slip-clutch end of the driveline
jackshaft (#2) to the gearbox input shaft (#1). Make
certain the slip-clutch is fully on the gearbox input
shaft. Tighten the conical dog pin on the connection
to 45-50 ft-lbs. of torque.
3. Insert driveline jackshaft (#2) through the bearing
support assembly (#3). Pull the bearing support
assembly fully against the jackshaft to extend the
jackshaft splines through the bearing and out the
other side as far as possible.
IMPORTANT: Make sure the bearing (#3) in bearing
support has its locking collar facing the cutter
gearbox (#1).